Adjusting the rising hinge mechanism


The screen won’t close

Applies to the following series/models

IBIZA2000 and NOVA2000 models with swinging/two-part hinged doors and rising hinge mechanism

In our care instructions we advise that for maintenance reasons the rising hinge screw should be tightened once a year.

If this is not carried out, the bearing plate can rotate internally and cause the position of the panels to change.

In this case you must:

  • loosen the hexagonal socket head screw in the closed and lowered state
  • open the door panel 90° and close it again
  • retighten the hexagon socket screw with the panel in the desired position

Please ensure that the door panel is fully lowered when the door is closed.

Kermi service: Adjusting the rising hinge mechanism